试题详情
- 单项选择题 Nexus# conf t Enter configuration commands， one per line. End with CNTL/Z. Nexus（config）# interface Loopback10 % Permission denied Nexus（config）# ？ no Negate a command or set its defaults username Configure user information. end Go to exec mode exit Exit from command interpreter What is the reason why this user is not able to enter configuration commands？（）
A、 The user did not enter enable prior to going into configuration mode.
B、 The software license installed on Nexus is Layer 2 only， which does not allow the creation of Layer 3 interfaces.
C、 The user RBAC role is set to network-operator.
D、 The user failed authentication and user access defaulted to read-only mode.
E、 The AAA server is currently not responding.
- C
关注下方微信公众号，在线模考后查看
热门试题
- 采用专用线路通信时，可以省去的通信阶段是
- TokenBus的媒体访问控制方法与其相
- In the C
- How does
- Why are
- What are two recomme
- What are
- You have
- The IP multicast glo
- Which command is use
- 如果让ping命令一直ping某一个主机
- What statement
- 主机A无法ping通HostB的。假设路
- What are the two rea
- A branch
- How should a router
- 请参见图示。图中所示的交换机已启用&en
- 在一个RSTP选举过程的结束，哪个交换机
- Which three statemen
- Refer to t